Our Partners

Displaying 1 total

Single Board Computers, I/O, Avionics Interfaces, Sensor & Signal Processing, MIL-1553, ARINC 429, AFDX Interfaces and Databus Analyzers, High Performance Embedded Computing (HPEC), Graphics & Video, Network Communications, Rugged Systems & Solutions


  • 0.1% DC accuracy
  • Current measurements up to 10 A, 20 A for up to 30 seconds
  • Millisecond pulse width measurements for fuel injectors
  • Optional magnetic hanger allows meter to attach to the vehicle and free your hands for other tasks
  • Min/Max/Average recording with Min/Max Alert to capture variations automatically
  • Peak Min/Max to record transients as fast as 250 μs
  • Relative mode to remove test lead resistance from low ohms measurements
  • Auto and manual ranging for maximum flexibility
  • Autohold™ to capture stable readings with only one touch of the leads
  • Large display digits and two-level bright white backlight for increased visibility
  • Analog bargraph to track changing or unstable signals
  • Input Alert provides audible warning against wrong use of input jacks
  • Access door for fast battery changes without opening up the case
  • "Classic" design that fits your hand with new removable holster, built-in test lead and probe storage
  • 10 meg ohm input impedance won’t damage computer circuits
  • Limited lifetime warranty


  • Power quality statistics according to EN50160
  • Voltage event list (dips, swells and interruptions)
  • Continuous recording of:
    • Voltage
    • Current
    • Power P, Q, S
    • Power factor
    • kWh
    • Flicker
    • Unbalance
    • Frequency
    • Voltage and current harmonics to the 50th / Interharmonics
    • THD
    • Mains signaling
  • Triggered recordings
  • Online mode (Oscilloscope, transients and events)
  • Fast transient analysis up to 10 MHz
  • 4, 600 V voltage probes
  • 4 dual-range flexible current probes (1000 A / 200 A AC)
  • GPS time sync receiver
  • 2 GB Flash Memory


  • A completely sealed, IP67 rated case
  • Withstands drops up to 10 ft or 3 m (with holster)
  • Dustproof per IEC 60529 IP6x
  • Waterproof per IEC 60529 IPx7
  • CAT III 1000 V, CAT IV 600 V
  • Reversible holster for added protection of the display when not in use


  • Provides the baseline multimeter features you need for troubleshooting and repairing electrical and electronic systems
  • Delivers accurate true-RMS AC current and voltage plus frequency, capacitance, resistance, continuity and diode measurements
  • Increases productivity with manual and automatic ranging, Display Hold, Auto Hold, and Min/Max-average recording


  • Identify complex signal problems fast
  • Supports accurate measurements on VFDs using a low-pass filter
  • Captures intermittents as fast as 250 µS with Peak Capture