Our Partners

Displaying 2 total

Digital & Vector Signal Analyzers, Signal Generators and Fast Synthesizers, Spectrum


  • 5608: –200 °C to 500 °C (80 mm minimum immersion)
  • 5609: –200 °C to 670 °C (100 mm minimum immersion)
  • ± 0.01 short-term stability
  • Calibration not included, NVLAP-accredited calibration optional, lab code 200348-0
  • Dry-well reference with 90 ° bend


  • Non-contact voltage detection
  • AutoVolt automatic AC/DC voltage selection
  • Prevent false readings caused by ghost voltage with selectable low-impedance mode


Fluke 789 Temperature Kit features:

  • Unique new wireless measurement logging capability
  • Temperature measurement from -200 °C to 1372 °C using the t3000 FC
  • 24 V Loop power supply
  • HART mode setting with loop power (adds 250 ohm resistor)
  • 100% larger dual display
  • 1200 ohm drive capability on mA source
  • Enhanced backlight with two brightness settings
  • 0% to 100% mA Span Check buttons to toggle between 4 and 20 mA
  • Infrared I/O serial port compatible with
  • FlukeView® Forms Software Version 2.1
  • Externally accessible fuses for easy replacement

These 787 features are also included in the 789:

  • DMM designed to meet 1000 volt IEC 1010 CAT III standards
  • Precision 1000 V, 440 mA True-RMS digital multimeter
  • Frequency measurement to 20 kHz
  • Min/Max/Average/Hold/Relative modes
  • Diode test and continuity beeper
  • Simultaneous mA and% of scale readout
  • 20 mA DC current source/loop calibrator/ simulator
  • Manual Step (100%, 25%, Coarse, Fine) plus Auto Step and Auto Ramp
  • Externally accessible battery for easy battery changes


Discover sources of electrical energy waste, identify energy savings opportunities, and conduct load studies.
  • Key measurements: Automatically capture and log voltage, current, power, power factor, energy and associated values
  • Convenient instrument powering: You can power the instrument directly from the measured circuit instead of mains outlets
  • Highest safety rating in the industry: 600 V CAT IV/1000 V CAT III rated for use at the service entrance and downstream


  • Low-cost thermocouple furnace
  • NIST-traceable calibration included
  • RS-232 port standard
You told us you weren’t satisfied with the competition’s furnaces for checking industrial thermocouples. You said you wanted something new and more convenient to use—and you wanted it at a lower price than any other furnace available. Well, we’ve got what you asked for, and it’s the Model 9150 Thermocouple Furnace from Hart Scientific.