DO 160 Section 19 Compliance: Generates chattering relay spike trains meeting RTCA DO 160 §19.3.5 and Boeing D6-16050-4 §7.5.2 requirements. 

Adjustable High Voltage Pulses: Up to 600 V burst amplitude, 0.2–10 µs spike width, 50–1000 µs burst duration. 

Intuitive Touchscreen Interface: 7″ display for real time control of polarity, burst length, and duty cycle. 

Dual Monitor Outputs: Two 1:1 Banana ports (≥100 MHz bandwidth) for precise oscilloscope verification. 

Robust Safety Design: Shrouded banana outputs, reinforced HV wiring, earth ground lug, and IP3X enclosure. 

Compact & Portable: 235 × 180 × 140 mm, 2.3 kg—ideal for laboratory or on aircraft test environments 

The Conformity Assessment Business Model DCS06 Test Generator has been designed to operate with its complementary injection clamp to fully meet the pulse requirements of DCS06 when tested into a 5? load. It operates from an intuitive touch screen interface and has full phase synchronization up to 800 Hz input frequency with 1-degree steps. It has been designed with future revisions of the test standard in mind. 

The Conformity Assessment Business Model DCS12 Test Generator meets all the DCS12 wave verification parameters for testing DC, single and three-phase equipment, that is source impedance and verification of damping and frequency when measured into a 10 Ω load. Output amplitude is software adjustable with permanent memory, should re-alignment be needed during calibration. 

There are three fixed outputs: 600 V, 750 V, and 2500 V 

15.9 kHz ±10 % 

10.9 kHz ±10 % 

The Conformity Assessment Business Model DCS05 Test Generator. When coupled to its matched test clamp, the Generator produces damped oscillatory wave transients in the frequency range 500kHz to 50 MHz that meet the definition of a type 1N Generator verification requirements Defence Standard 59-411. 9 Fixed frequencies are available: 500 kHz, 1 MHz, 2 MHz, 3 MHz, 5 MHz, 10 MHz, 15 MHz, 35 MHz, and 50 MHz. 

Matched test clamp for DCS05 Test Generator, the Generator produces damped oscillatory wave transients in the frequency range 500kHz to 50 MHz that meet the definition of a type 1N Generator verification requirements Defence Standard 59-411. 9 Fixed frequencies are available: 500 kHz, 1 MHz, 2 MHz, 3 MHz, 5 MHz, 10 MHz, 15 MHz, 35 MHz, and 50 MHz. 

The Conformity Assessment Business Model DCS06 Clamp is designed and tuned for optimal operation in the 100 kHz frequency range and provides efficient coupling of the Defence Standard 59-411 DCS06 pulse to the EUT at voltages up to 1 kV (single turn output) and 4 kV (4 turn output). A single turn monitor loop is provided for pulse amplitude measurement during the test.