• Red laser for long lines and good visibility
• Optical output power up to 40mW/635 nm
• Integrated power supply with high immunity to interference
• Dimensions: Ø 40mm x 200m
• wide range input, 90-265VAC

The ZR is a red positioning laser with an asymmetric optic that projects especially long and homogeneous lines for precise alignment. With an optical output of up to 40 mW at 635 nm, it provides excellent visibility even across large working areas. An integrated heavy-duty power supply with a wide input range (90–265 VAC) ensures strong interference resistance and reliable operation under demanding industrial conditions. Compact dimensions of Ø 40 mm x 200 mm make it easy to integrate into machines and systems. Typical applications include textile tables and circular saws, where long and uniform line projection is critical for accuracy.

• Supports PCI Express Rev 2.0 x4 or higher, backwards compatible with PCIe Rev 1.10 slots 
• Up to 512MB of high-speed image memory 
• Single slot solution with reconfigurable camera control and general purpose input/outputs

Reed position sensors offer a versatile and contactless solution for detecting movement and position using magnetic fields. Built around a reed switch mechanism, these sensors operate by opening or closing in response to a nearby magnet, enabling precise and repeatable switching. Available in a wide range of sizes, mounting styles, and electrical configurations, they are ideal for applications in industrial automation, medical devices, fluid level monitoring, and consumer electronics. Their solid-state design ensures long operational life, resistance to shock and vibration, and compatibility with low-voltage systems.

Transmission line probes are a special type of passive probe designed for use at very high frequencies. They replace the high impedance probe cable found in a traditional passive probe with a precision transmission line, with a characteristic impedance that matches the oscilloscope input (50 Ohm). This greatly reduces the input capacitance to a fraction of a picofarad, minimizing the loading of high frequency signals. A matching network at the tip increases the DC input resistance. While they have lower DC input resistance than a traditional passive probe (usually 500 Ohm) to 1kOhm), the input impedance of these probes remains nearly constant over their entire frequency range. A traditional /10 passive probe will have a 10 MOhm) input impedance at DC, however this impedance drops rapidly with frequency, passing below the input impedance of a transmission line probe at less than 100 MHz.

DC, RF and Optical Probe Positioning for Highest Accuracy Measurements

FormFactor offers a wide variety of manual and motorized probe positioners for any application from DC to terahertz measurements and beyond.

• Guaranteed performance to 43.5 GHz with Extended K™ ports
• High output power allows measurement of high attenuation devices
• Advanced time domain option provides tools for signal integrity analysis
• Wide dynamic range enables measurement of very low reflection artifacts
• Excellent corrected directivity minimizes measurement uncertainty
• SmartCal™ auto calibration unit reduces calibration and setup time
• Time domain with time gating option grants easier and faster fault identification
• Modern LAN interface for remote control is faster than GPIB
• A common GUI and SCPI interface within the ShockLine family
• Bias tee option simplifies test setups where the DUT needs DC biasing
• Universal Fixture Extraction (UFX) software option provides advanced de-embedding tools for test fixture extraction
• E-Band VNA
  • Extended frequency range covering E-band and major parts of V band
  • Fully assembled test system eliminates setup errors and increases reliability
  • Tethered modules connect directly to the DUT increasing measurement stability